Social Media:  Facebook Fabian Enterprises Ltd MALTA

Fabian Enterprises Ltd MALTA

RC522 RFID MODULE

Product Code: HR0232

Price: €4.86 (Incl Vat)


Product Description:


The RC522 is an RFID module that is based on the MFRC522 controller from NXP semiconductors. The module can supports I2C, SPI and UART.

  • 13.56MHz RFID module
  • Operating voltage: 2.5V to 3.3V
  • Communication : SPI, I2C protocol, UART
  • Maximum Data Rate: 10Mbps
  • Read Range: 5cm
  • Current Consumption: 13-26mA
  • Power down mode consumption: 10uA (min)

The RC522 is a RF Module that consists of a RFID reader, RFID card and a key chain. The module operates 13.56MHz which is industrial (ISM) band and hence can be used without any license problem. The module operates at 3.3V typically and hence commonly used in 3.3V designs.  It is normally used in application where certain person/object has to be identified with a unique ID.

The keychain has 1kB memory in it which can be used to stored unique data. The RC522 reader module can both read and write data into these memory elements. The reader can read data only form passive tags that operate on 13.56MHz.

The RC522 has an operating voltage between 2.5V to 3.3V and hence is normally powered by 3.3V and should be used with 3.3V communication lines. But, the communication pins of this module are 5V tolerant and hence it can be used with 5V microcontrollers also like Arduino without any additional hardware. The module supports SPI, IIC and UART communication but out of these SPI is often used since it is the fasted with a maximum data rate of 10Mbps.

Since in application, most of the time reader module will be waiting for the tag to come into proximity. The Reader can be put into power down mode to save power in battery operated applications. This can be achieved by using the IRQ pin on the module. The minimum current consumed by the module during power down mode will be 10uA only. The module can be easily used with Arduino because of its readily available RC522 RFID Arduino library from Miguel Balboa. You can visit his GitHub page for more details on how to use it with Arduino.

Pin Name Description
1       Vcc Used to Power the module, typically 3.3V is used
2 RST Reset pin – used to reset or power down the module
3 Ground Connected to Ground of system
4 IRQ Interrupt pin – used to wake up the module when a
    device comes into range
5 MISO / SCL / Tx     MISO pin when used for SPI communication, acts 
    as SCL for I2c and Tx for UART.
6 MOSI Master out slave in pin for SPI communication
7 SCK Serial Clock pin – used to provide clock source
8 SS / SDA / Rx Acts as Serial input (SS) for SPI communication, 
    SDA for IIC and Rx during UART



Suppliers ANTEX, BLUE SEA, STANDARD HORIZON, UNI-T, ELFA DISTRELEC